Sangean DDR-63+ (V1) - Manual (Page 20)

9
WPA and WPA2 are similar, although WPA2 offers a higher level of security. Whichever you selected
in step 7, you then have to specify the variant used. They are TKIP (Temporal Key Integrity Protocol)
and AES (Advanced Encryption Standard). As previously, the setting should match that used by
your router. Some routers allow both to be specified, and the router will use whichever variant is
supported by the connected device. AES is regarded as the more secure option if it is available.
The radio will then require you to enter the encryption key. This must be a string of between
8 and 63 characters and must be identical to the key which has been entered into your router.
Note – the encryption key is sensitive to the use of upper and lower case letters and symbols.
Take care to enter the key exactly, or the radio will not be able to connect to your router. The
three controls on the right-hand side of the screen have special functions. You can quickly access
these by pressing the Info button and then use the Folder Up or Down and Select
buttons as needed:
select ‘ ’ to erase a character just entered (long press to clear ); Info again to continue
select ‘ ’ when the complete encryption key has been entered
select ‘ ’ to cancel and go back to the TKIP / AES options screen
Once the key is entered the radio should connect to the network.
While the radio is trying to connect to the network, it will display ‘Processing…’ when checking the
encryption key (if using the WiFi connection) and then ‘Connecting…’. If the connection is made
successfully, the radio will return to the Network settings menu. If the unit cannot connect, then it
will display a ‘Failed to connect’ message and will return to the SSID entry screen (step 6).Once
connected, the network settings are stored in the radio. The settings are retained whenthe radio is
disconnected from the mains. You may now use the Back and Radio or Media buttons to access
the functions of your radio.
9.
10.
.
The three controls on the right-hand side of the screen have special functions. You can quickly
access these by pressing the Info button and then use the MenuUp or Down and Select buttons
as needed:
select ‘ ’ to erase a character just entered (long press to clear); Info again to continue
select ‘ ’ when the complete encryption key has been entered
select ‘ ’ to cancel and go back to the SSID settings screen
Once the key is entered the radio should connect to your network. Please skip to step 11.