Sangean DDR-63+ (V1) - Manual (Page 19)

8
GB
In most installations the DNS settings (DNS = Domain Name Server) will be set to the same IP
address as your router. In this case the secondary DNS may be left at zero. To enter the DNS address,
press the Folder Up or Down buttons on the remote control to set the value for each group of digits
and then press the Select button or the Left or Right buttons (on the remote control) to enter the value
and to move on to the next group. Repeat this until all eight groups of digits have been entered. If
you previously specified ‘Wired’ and then ‘DHCP disable’, your radio should now connect to the router
using the Ethernet cable (in which case skip to step 11).
If you specified ‘Wireless’, the next step is to set up the WiFi connection, starting with the name of
the wireless network (SSID) followed by the encryption options and password. To enterthe SSID,
characters are selected and entered using the Folder Up or Down, Left or Right on the remote control
and Select buttons. The radio scrolls through the available characters as well as the three controls
on the right. The character currently highlighted will be entered when you press theSelect button.
Do this as needed until the complete network name has been entered. The SSID setting is sensitive
to upper and lower case characters and symbols. You must enter it exactly as set up in your router.
The three controls on the right-hand side of the screen have special functions.
You can quickly access these by pressing the Info button and then use the Folder Up or Down and
Select buttons on the remote control as needed:
select ‘ ’ to erase a character just entered (long press to clear); Info again to continue
select ‘ ’ when the complete SSID has been entered
select ‘ ’ to cancel and go back to the DNS settings screen
Having entered the SSID, you must enter details of the encryption system used on your wireless
network. This should be the same as specified in your router settings. If your network does not use
encryption, then select the ‘Open’ option. Your radio should then connect to the network, so skip to
step 11. If your network uses WEP (Wired Equivalent Privacy) select the ‘Pre-Shared Key’ option
then go to step 8. The remaining options are for WPA or WPA2 (WiFi Protected Access) – see step 9.
If you chose ‘Pre-Shared Key’ in step 7, you should then choose the WEP option. The key should
be entered using only the numbers 0-9 and the letters A-F. The key will be 10 characters long for
64-bit encryption and 26 characters long for 128-bit encryption. The radio willaccept lower-case
letters a-f as equivalent to upper-case A-F. Spaces or special symbols are not permitted in WEP keys.
5.
6.
7.
8.