Sangean DDR-63+ (V1) - Manual (Page 89)

88
GB
Disabling alarms
To disable a single alarm enter the alarm setup menu and press the Folder Up or Down buttons
until the desired alarm is highlighted on the display. Press the Select button.
Press the Folder Up or Down buttons until the 'Enable:' option is highlighted on the display.
Press the Select button.
Press the Folder Up or Down buttons to highlight 'Off' and press the Select button.
Press the Folder Up or Down buttons until the 'Save' option is highlighted on the display then
press the Select button to save the new setting. The chosen alarm will now be disabled.
.
.
.
.
Controlling alarms in standby
When your radio is in standby the alarms can be controlled using the Alarm button. This avoids
the risk of disturbance to someone who is asleep.
To change the states of the alarms when in standby press the Alarm button. The display will
cycle through none, either and both alarms enabled. .