Figure 11-21, Figure 11-22 – CANOGA PERKINS 9145EMP NID Software Version 4.0 User Manual
Page 171
9145EMP NID Software User’s Manual
Service OAM
Maintenance End Points
156
Figure 11-21 Maintenance End Point Attributes screen (802.1ag)
Figure 11-22 Maintenance End Point Attributes screen (Y.1731)
Canoga Perkins Corp. Ethernet Network Interface Device 02-JAN-2011
9145EMP-761-4-0 V40.43 Canoga 9145EMP 32 device 11:20:59
-----------------------MAINTENANCE END POINT ATTRIBUTES-------------------------
MEP ID: 1028 Direction: Up Level: 1VLAN Type: C-VLAN
MA ID: 28 Port: USR2 MAC: 00:40:2A:01:EE:23
1) Admin status: Enabled
2) CCM Transmit status: Disabled
3) Primary VLAN ID: 104
4) Fault alarm Detect time: 2500
5) Fault alarm clear time : 10000
6) CCM/LTM Priority: 7
7) Lowest alarm priority: MacRemErrXcon
Fault notification state: Defect reported
Defects: RemCCM
Next Linktrace trans. ID: 1 Next Loopback trans. ID: 1
Select [1-7], (T) for Linktrace, (L) for Loopback:
------------------------------------Messages-----------------------------------
Canoga Perkins Corp. Ethernet Network Interface Device 02-JAN-2011
9145EMP-761-4-0 V40.43 Canoga 9145EMP 32 device 11:20:59
-----------------------MAINTENANCE END POINT ATTRIBUTES-------------------------
MEP ID: 1 Direction: Up Level: 7
MEG ID: 101 Port: User MAC: 00:40:2A:01:EE:23
1) Admin status: Enabled
2) CCM Transmit status: Enabled
3) Primary VLAN ID: 900
4) Fault alarm Detect time: 2500
5) Fault alarm clear time: 10000
6) CCM/LTM Priority: 7
7) Lowest alarm priority: MacRemErrXcon A is
Fault notification state: Defect reported
Defects: Random
Next Linktrace trans. ID: 1 Next Loopback trans. ID: 2
8) AIS Transmit interval: 1 sec
9) AIS Priority bits: 1
Select [1-9], (T) for Linktrace, (L) for Loopback:
------------------------------------Messages-----------------------------------