Line data input, With input roller), Attention – Daiwa TANACOM BULL 750 User Manual

Page 13

Advertising
background image

11

9

Do not reel in the end of the line

MAX

OFF

8

7.

Take off the Input Roller.

8.

Pull the Power Lever to the OFF position once again. (The

beep will then be heard.)

9.

Push again the Power Lever forward to maximum and wind the

remaining line to fill the spool.

Be careful not to wind up the end of the line because it may cause

an error.

Line data input

(with Input Roller)

Attention

1.Do not allow line to rub against the finger guard while winding as it will scratch the guard.

2.

When the line is wound indoors for a long time (15 min. or more) at a high tension, the

motor may heat up abnormally and cause problems, such as deterioration of winding
power, speed, etc., so electric winding is stopped automatically. Input line at as a high
speed as possible. When actually fishing, there will be no problem because it is cooled
down with sea water, etc. When it stops, wind up manually or pull the power lever back
up and down again towards the MAX side to rewind it and re-input line.

3.

Do not wind the end of the line onto the spool because it causes incorrect length

calculation. Move the power lever to OFF, and wind manually when nearing the end of the
line.

OFF

10.

Pull the power lever back to the OFF position when only

about 10 m of the line to be wound remains. (This will stop

electric winding.)

(Alarm sound)

11

Should “

Err

” appear on the display, then use the

MODE SET

BUTTON

to re-enter the data.

11.

When the line is wound until the position just before the end,

press the RESET BUTTON

RESET BUTTON for more than 2 seconds. When you

hear the alarm sound and the display shows 0.0

0.0, the line data

input is complete.

Line’s end

Advertising