Daiwa TANACOM BULL 750 - Manual (Page 27)

25
4. Following the operations of 2 and 3, set the waiting time
(second) and then range (m).
By pressing the JIG/PICKUP BUTTON at any jigging setting
display, you can finish the jigging setting at that point and the
display will show depth and begin jigging.
Pressing and holding the MODE BUTTON will quickly scroll you
back to the depth counter display.
Jigging
2
Jigging is an extremely valuable function.
After setting your preferences, pressing the JIG/PICKUP BUTTON starts the function.
Speed of the jigging can be adjusted with the power lever.
1
3
5
1. Press the MODE BUTTON to show Jig/pickup display.
(The figure at right shows the default pickup display. To set
jigging, display the jigging pattern display.)
When jigging is chosen, the pickup function cannot be used.
2. Jigging pattern is selected with the power lever.
There are four patterns; 123 (master), 1 step, 2 steps, 3 steps.
Jigging setting displays appear in the following order;
Pattern (step) > length (m) > waiting time (sec) > range (m)
3.
Press the MODE BUTTON and the pattern setting is complete
when the next display is shown.
Jigging setting display appears.
5. After pressing the JIG/PICKUP BUTTON , jigging starts with the
power set with the power lever.
Jigging speed is controlled with the power lever.
As the jerking starts, indicator blinks.
Pressing the JIG/PICKUP BUTTON again stops jigging.
(When it is in the OFF position, (JIG) indicator blinks but it does
not wind up.
During the jigging, you can stop jigging by pressing the
JIG/PICKUP BUTTON or by positioning the power lever at OFF
(alarm sound).
Functional setting operation
(7. Jigging)