Daiwa TANACOM BULL 750 - Manual (Page 9)

7
MODE BUTTON
Press the MODE BUTTON to scroll through the adjustment displays for each reel function.
- Use the Power Lever to adjust numeric values.
- Pressing the MODE BUTTON sets the numeric values you have adjusted.
- Depress and hold the MODE BUTTON to return to the depth display.
- Mode change cannot be done while line is being fed.
RESET BUTTON
This button resets the depth counter to zero.
Make sure to press this button before you start fishing. The reset depth is used to make the auto stop function
work. (display shows ). The default setting of auto stop is 2 meters.
To prevent an operational error, the RESET BUTTON needs to be pressed for more than 2 seconds with the setting
of 10 m or more.
This prevents accidental resetting. For a total reset, when line has been broken off, press and hold the button for at
least 2 seconds.
INVERSE COUNTER BUTTON
Pressing this button resets the counter in the lower area of the display.
- It memorizes distance from the bottom, handy for dropping a bait right back into the strike zone after youʼve been
bit.
- The chumming timer resumes after pressing this button.
JIG/PICKUP BUTTON
Selection between pickup and jigging can be done in the mode setting display.(One of them should necessarily be chosen.)
Pickup
-You can wind only while pressing this button. This function is useful to wind up line slack and attract fish.
- Winding speed can be changed with the mode setting display. (Default setting is speed 15)
Jigging
- Jigging can be ON/OFF.
- Pressing this button starts jigging. (Display shows )
- Pressing the button again stops jigging.
Mode display
- This display allows you to change setting of each function.
- The functions that are set to work are shown on the display.(Default setting is speed 15, but the speed can
actually be set between 0~Hi.)
Depth counter
- It shows the depth from the surface.
Chumming timer (Power indicator, time to wind up, timer display)
- The chumming timer appears when motor rotation is stopped.The timer display cannot be set to OFF.
- While using the power lever, the power level is shown.
- While the electric winding up is in action displaying actual winding speed, the timer indicates the remaining time to
auto stop at the ship side(in minutes and seconds).
Jigging display
- This is appeared only when the jigging function is on.
- It blinks when jigging is in process.
Display Function Function Display
Pressing the JIG/PICKUP BUTTON
makes the function work. Pressing the
button again stops it.
Chumming timer starts working.
Auto Line feeding is employed. Default
setting is off.
Pressing the RESET BUTTON makes this
indicator appear, telling you auto stop will
work.
Only while pressing the JIG/PICKUP
BUTTON will the motor run to wind line.
Names of the buttons and the display
1
5
9
8
4
6
7
2
3
Inverse counter (winding speed display)
- This counter shows the depth from the bottom (or a
certain depth).
- Once this counter is turned on, its display cannot
be turned off.
- While winding up, winding speed appears in meters
per minute.
(The display of winding speed can be set to OFF)