Daiwa TANACOM BULL 750 - Manual (Page 15)

13
Attention
Do not wind up the end of the line. Turn the power lever at OFF position before the end
(stop electric winding), and wind up the remaining line manually. When the end of the
line is wound up electrically, it may cause an error on the counter.
7
MAX
OFF
OFF
5
6
8
6. When the line is wound until the position just before the end,
press the RESET BUTTON for more than 2 seconds, until the
display shows 500 . (Default value is 500). The value may be
different once it is reset.
5. Pull the power lever back to the OFF position when only about
10 m of the line to be wound remains. (This will stop electric
winding.)
(Alarm sound)
7.
Enter the line length with the power lever. (in the figure on the
right, line length is 1000 m).
(The value increases/decreases with operation of the power lever.
The right figure is when it is set to 700 m.
8. When set at the length wound, press the RESET BUTTON for
more than 2 seconds.
If “ Err ” appears on the display, you must use the MODE SET
BUTTON to re-enter the data.
Do not reel in the end of the line
Line data input
(When line length is known---P1)
8. Press RESET BUTTON for 2 seconds and a beep will be
heard. The display should return to 0.0 , completing the setting
procedure.
Line’s end