Panasonic NV-J45 Series - Manual (Page 13)

Setting the Clock to the Present Time (Cont’d)
Setting the Clock to the Present Time Using the Bar
Codes
itttt
1
B-------------------- __ _
X til II
.<: m rr III « 4111
i'i t'W lili
:'i mi h ilil
I un X INI Mil
<! im lili
'1 ilil >: ili|
•1 lili 1i lili - IIH
■! lili Xi lili
• lili ■ «II a iiii
lili 'X lili i'i 111
r lili « III U. Ill
l> lili xi m
l"i lili -1 «III xj illl
lili «1 illl h IlU
< lili 111 X. lili
x lili M i M' ihl
X lili Xi Ull
X tlll x^ lili X: IlU
a i t i
r ilU : Jiti
m Ull tur
; iiiih
IM M
Ifl
it w
Preparation
• Press the Digital Scanner On/Off Button to turn it “ON”.
1 Trace the bar code “SETTING OF THE CLOCK”.
SETTING OF THE CLOCK
□-
2 Trace the bar code for the year (YEAR).
39
1IMQ-
3 Trace the bar code for the month (MONTH).
MONTH
m-m
4 Trace the bar code for the day of the month (DATE).
2 DATE
0MI»
5 Trace the bar code for the hour (START TIME).
6 Trace the bar code for the minute (MIN).
5 . m
■ <(j
7 Press the Transmit Button (Remote Controller) and
then confirm that the time is displayed in the
Multi-Function Display of the VTR.
8 Press the Digital Scanner On/Off Button to turn it
“OFF”.
• if the transmission was not received correctly, the
“Beep-Beep, Beep-Beep” sound from the VTR will warn
you. In this case, perform transmission again.
• If the Remote Controller is left with no operation
performed for more than 4 minutes, it will automatically
switch over to the power-saving standby condition and
the lamp in the reading tip goes out. In this case, bar
codes that have already been read (but not yet
transmitted to the VTR) will be cancelled.
• The bar codes “SETTING OF THE CLOCK”, “YEAR”
and "MONTH” are located on page 3 of the
Programming Sheet.
3 START TIME
Q-nn 9
JUU •
(13)