Panasonic NV-J45 Series - Manual (Page 29)

Timer Recording (Cont’d)
Transmit the Programming Data
Keep pressing the Transmit Button and confirm that the
programmed data on the Multi-Function Display of the
VTR are as desired.
After releasing the button, the data will continue to be
displayed for about 12 seconds.
“Beep-beep-beep-beep-
beep...” sound indicates
programming is completed.
• If the transmission was not received correctly, the
“Beep-Beep, Beep-Beep" sound from the VTR will warn
you. In this case, perform transmission again.
• The transmission is possible when the VTR is turned on
but is not in any of the recording or playback operation
modes. It is also possible when the VTR is in the timer
recording standby mode (H indication is lit),
• The programming will be done on the next lower
unoccupied timer programme number (8-1).
• If all programme numbers are occupied, the
“Beep-Beep, Beep-Beep” sound from the VTR will warn
you that the programming cannot be made.
• When the Transmit Button is pressed, the VTR will
automatically be put into the timer recording standby
condition and the VTR will be turned off.
Timer On/Off
After programming a timer recording, the VTR is in the
timer recording standby mode and cannot be used for any
other operation, such as playback. If some other operation
is desired, first trace the “TIMER ON/OFF” bar code and
transmit it to the VTR with the Transmit Button.
To later reset the VTR to the timer recording standby
mode, trace the “TIMER ON/OFF" bar code again and
transmit it with the Transmit Button.
^ ^
TIMER ON/OFF
□-
r
L
For Programming More Than One Timer Recording in
Succession
Repeat the following operation steps 1-3.
1 Trace the “CANCEL” bar code on the Programming
Sheet.
CANCEL
2 Trace the bar codes for “CHANNEL”, “DATE”,
“START TIME”, “END TIME” and “RECORDING”.
3
Confirm that the present time is displayed on the
Multi-Function Display of the VTR, and transmit the
data.
• If the next timer programming data are transmitted
while the previous timer programming data are still
being displayed, the displayed timer recording data
will be cancelled.
AV
For Timer Recording of signals input via Video input
Socket and Audio Input Socket, trace the “AV 1” bar code
for “CHANNEL” to select the “A1 ” programme position.
Note:
The "AV 2” bar code cannot be used with this VTR.
<
29
)