Panasonic NV-J45 Series - Manual (Page 36)

Dubbing (Copying) (Cont’d)
Connecting to a Movie Camera Equipped with
Synchro Edit Function
It is possible to synchronize the playback start and stop of
the Movie Camera with the recording start and stop of this
VTR.
Preparation
• Make the necessary connections as shown in the
connection diagram.
• Set the Edit Switch (Noise Fiiter/Edit Selector) on both
the Movie Camera and this VTR to “ON” (or “EDIT ON").
• Press the Input Signal Selector on the Remote Controller
to select the “A1 ’’ programme position (or select with the
Channel Up or Down Button on the VTR).
1 Put the VTR in the recording pause mode.
2 Put the Movie Camera in the still playback mode.
• Put the Movie at the point where you want to start
editing into the still playback mode.
3
Press the Pause/Stili Button on the VTR.
• The Movie Camera changes over to the playback
mode and the dubbing will start automatically.
To Leave Out Unwanted Scenes * •
1 Press the Pause/Still Button on the VTR.
The VTR changes over to the recording pause mode
and the Movie Camera changes over to the still
playback mode.
2
Operate the Movie Camera to skip the unwanted
scenes and then put it in the still playback mode again.
3
Press the Pause/Still Button on the VTR.
• The dubbing will restart.
To stop the dubbing, press the Stop Button on the VTR
and then put the Movie Camera in the stop mode.
Synchronized Editing between the VTRs______________
When editing from another VTR equipped with Synchro
Edit Socket, synchronised start and stop of both VTRs can
be activated from this VTR.
r
The operation Is the same as described on the left for
synchronized editing from a Movie Camera.
(
36
)