Panasonic NV-J45 Series - Manual (Page 20)

Playback (Cont’d)
Clock/Counter Selector
CLOCK/
COUNTER-TAPE REMAIN
o o
MONITOR
O
Indication of the Remaining Tape Time_____________
When the Tape Remain Button on the Remote Controller
is pressed during playback or recording mode, the
approximate remaining tape time will be displayed in hours
and minutes.
By pressing this button when the VTR On/Off Switch is set
to “On”, it is possible to change over the display mode of
the Clock/Counter Display in the Multi-Function Display
from "Clock” to "Counter” Display and vice versa.
• Even if the selector button is set for “Counter”, the
display will automatically changes over to “Clock"
Display in all the following cases; When you set the VTR
On/Off Switch to “Off”, adjust the clock to present time,
programme a timer recording, check a timer recording
programme or programme and perform an OTR,
• When the Clock/Counter Display shows the time, the
counter cannot be reset.
Monitoring Function
When the Monitor Button is kept pressed during Playback
or Still playback, the broadcast picture of the selected
programme position (channel) or input signal through
Audio/Video input socket will be displayed. When this
button is released, the picture will change back to the
playback picture of the tape.
'
• The Remaining Tape Time Indication will remain
displayed even after the tape is ejected. However,
when next inserting a cassette, this indication will be
cancelled.
• When using a VHS-C videocassette in this VTR, the
remaining tape time indication may not be correct or
this indication may not appear at all.
• To return to the Tape Counter indication, press the
Tape Remain Button again.
(
20
)