Loading documents, Resolution, Basic transmission settings – Panasonic Panafax UF-160 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Loading Documents
First, make sure that your document is free of
staples, paper clips, and is not torn, greased or
covered by any foreign objects.
Place the document face down on the Automatic
Document Feeder (ADF) with the top edge going
into the machine and slide forward until it stops.
Adjust the sliding document guides to ensure that
the document is centered on the ADF.
If you are sending two or more pages, make sure
that the bottom sheet enters first. You can also
stack up to 10 sheets on ADF at one time. If you
want to send more pages, you can place them
on top of the last page on the ADF once
transmission has started, as long as you do not
have more than 10 sheets on the ADF at any one
time.
When you set a document on the ADF the display
message will change from date and time
(standby) to DOCUMENT SET. You can now
make basic transmission settings, or begin the
dialing procedure.
DOCUMENT SET
32
Face down
INCORRECT
BASIC TRANSMISSION SETTINGS
You can temporarily change seven basic settings (Resolution, Contrast, Halftone,
Total Pages, Verification Stamp, individual Transmission Journal and Error Correction
Mode) before any ordinary transmission. These settings can be changed before or
after you place documents on the ADF. After you finish transmission, your machine
will automatically return to the preset settings. You can also change these settings
during transmission.
Resolution
Your machine is preset to Standard resolution, which is suitable for ordinary
documents. Use FINE or Super-FINE for very detailed documents.
1
RESOLUTION
DOCUMENT SET
RESOLUTION=STD
(STD = Standard)
2
RESOLUTION
DOCUMENT SET
R E S O L U T I O N = F I N E
If satisfied, go to Step 4.
DOCUMENT SET
R E S O L U T I O N = S F I N E
(S FINE = Super-FINE)
To return to Standard, press
I RESOLUTIO'Ñl again.
You can now dial by pressing
i
TEL/DIAL
I
and a full number,
ABBR
j
and two
a One-Touch key,
digits, or {REDIAL
NOTC
1. After changing the Resolution setting, you can
a) go to standby with ( STOP
b) make a copy of the document to test the new Contrast setting by pressing ICOPY
c) start a different series of settings by pressing | RESOLUTION I. | HALF TONE
rSTAMP I; MODE r^m , or [FUNCTION |.
2. To change the preset Resolution position, see page 26 - 29.
33
Г