Adjusting the automatic document feeder (adf), Refilling the verification stamp unit, 94 refilling the verification stamp unit – Panasonic Panafax UF-160 User Manual
Page 49
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Adjusting the Automatic Document Feeder (ADF)
If misfeeding of a document happens frequently, we suggest you adjust the ADF
following the procedure below.
1, Open the Receiving Unit by depressing the latch button.
2. Unlock the ADF unit by gently pulling up both sides of ADF.
5
.
Adjust the Pressure Plate. ‘
Position 4
Set to this position if the feed trouble does not improve at Position 3.
Position 3
To prevent multiple feed trouble
Position 2
Standard Position
Position 1
To prevent non-feed trouble
NOTC
If the feed trouble continues after setting to Position 4, please call your service
representative.
94
Refilling the Verification Stamp Unit
The verification stamp unit contains ink. When the stamp appears faded or hard to
read, refill the stamp unit with ink.
To refill the stamp unit,
1. Open the Receiving Unit
by depressing the latch
button on the right side
panel, and swinging the
Receiving Unit forward.
2. Lift out the paper roll
inside. (Note carefully
the direction of the paper
so that you can replace
the roll correctly later
on.)
12
lllllllill!
3.
Turn
the
Recording
Paper Guide Plate and
the Transmitting Eject
Guide
Plate
towards
you. You can now see
the verification stamp
unit.
4
.
insert
a
flathead
screwdriver
into
the
groove of the unit and
slide the unit forward.
S.
Puli the stamp unit out
with a pair of tweezers.
NOTC
placing one drop of ink
into the refill hole.
7. Replace the stamp unit
by following the above
instructions
in
the
reverse order.
When the stamp unit is set as above, the stamp will appear on the front side of each
page. If you want the stamp to appear on the back side of each page, ask your service
personnel to change the stamp unit.
95