Panasonic Panafax UF-160 - Manual (Page 21)

Error Correction Mode (ECM)
ECM mode provides error free copy when your fax machine is connected with a
receiving fax machine which has ECM mode capability and your ECM mode is set
to ON. The transmission time required in the ECM mode is the same as the normal
G3 mode in most cases.
Your machine is preset to ECM = ON. If the telephone line is poor, then the
transmission will take longer because the machine will have to retransmit the tines
that have errors. In the case where the transmission time is more important than the
quality of the received copy, you may set your fax machine to ECM = OFF. This
will inhibit the ECM mode for the transmission regardless of the capability of the
receiving machine. To set ECM = OFF,
1
38
- MODE 4
C------ 1C—)
DOCUMENT SET
ECM=ON
repeatedly.
В
DOCUMENT SET
ECM=OFF
To return to ECM = ON, press [ SELECT j
again.
You can now dial by pressing I TEL/DIALI
and a full number, a One-Touch key,
IABBR I and two digits, or 1 REDIAL | .
NOT€
1, After changing the ECM setting, you can
a) return to standby with STOP
b) start a different series of settings by pressing | RESOLUTION
I STAMP I, [HALF TONE I, M O D E Q Q - orlFUNCTIONT
2. To change the preset ECM position, see page 26 - 29.
i ORIGINAL I
Automatic Individual Transmission Journal (XMT JRNL)
You may want to keep a separate record of each transmission you make to some
or all your clients. Your machine can save you the trouble of writing records by printing
out a Transmission Journal for you at the end of any particular transmission To set
XMT JRNL = ON,
1
‘ MODE 4
C------ IIZZ
or
DOCUMENT SET
XMT J R N L = O F F
repeatedly.
DOCUMENT SET
XMT J R N L = O N
To return to XMT JRNL = OFF, press
I SELECT! again.
You can now dial by pressing [TEL/DIAL 1
and a full number, a, One-Touch key,
I ABBR I and two digits, or [REDIAL I.
ноте
1. After changing the XMT JRNL setting, you can
a) return to standby with [ STOP j.
b) start a different series of settings by pressing [RESOLUTION I. ÍORIGINAL
[ half T0N~ e 1 . [STAMP] MODE Pnrn , or [^NCTI^fTT
2. To charige the preset XMT JRNL position, see page 26 - 29.
39
I,
'’'I
Н;
11