Panasonic Panafax UF-160 - Manual (Page 19)

Contrast (Original)
Your machine is preset to NORMAL contrast. If you have to send a document with
dark contrast, you may get better results by changing the setting to DARK, if you
have to send a document with light contrast, it may be wise to change the setting
to LIGHT. As a test, you can make a trial copy before transmitting (see page 50).
1
34
DOCUMENT SET
O R I G I N A L = N O R M A L
If satisfied, go to step 4.
DOCUMENT SET 2
DOCUMENT SET
O R I G I N A L = D A R K HALF TOME
Q O
HALF TONE=ON
S
DOCUMENT SET
O R I G I N A L = L I G H T
To return to NORMAL, press I ORIGINAL
again.
You can now dial by pressing
ITEUDIALI and a full number.
a One-Touch key, [ ABBR] and two
digits, or 1 REDIAL
NOTC
1. After changing the Original setting, you can
a) go to standby with (STOP].
b) make a copy of the document to test the new Contrast setting by pressing
\ COPY
c) start a different series of settings by pressing | RESOLUTION j. | HALF TONE
I STAMP I, MODE rn rn . of rFU^CTION [.
2. To change the preset Original position, see page 26 - 29.
Halftone
The Halftone setting is useful when sending photographs or illustrations with gray
tones. Your machine is preset to HALF TONE = OFF. To switch to HALF TONE = ON,
1 DOCUMENT SET
H A L F TONE=0FF
Your display should show HALF
TONE = OFF.
In this case Resolution is automatically
set at FINE. If you wish to go to HALF
TONE = OFF, press I HALF TONE] again.
You can now dial by pressing [TEL/PIALi
and a full number, a One-Touch key,
I ABBR I and two digits, or I REDIAL I.
NOTC
After changing the Halftone setting, you can
a) return to standby with [STOP [.
b) make a copy of the document to test the new Halftone setting by pressing | COPY!.
c) start a different series of settings by pressing |ORIGINAL | . (STAMP} . MODE
s en . or I FUNCTION I.
35