ChemoMetec NC-3000 - Manual (Page 29)

4 Start-up
991-3001 Rev. 1.3 June-2013 13
4 Start-up
4.1 Power on, power off
On the rear of the instrument two plugs and one fuse holder are located. When seen
from the rear the USB 2.0 port is to the left and the fuse holder and DC Power Plug
is at the right. The NucleoCounter
®
NC- 3000™ is powered by a 24VDC external
power supply. To connect the power supply to the NucleoCounter
®
, connect it to the
DC Power Plug (see Figure 6), and plug the mains power cord of the power supply
into a wall outlet.
Figure 6. Rear side of the NucleoCounter
®
NC-3000 ™
The NucleoCounter
®
NC- 3000™ can now be turned On once the wall outlet is On.
To power it Off, either remove the DC Power Plug or turn the wall outlet Off.
Figure 7 USB 2.0 Figure 8 DC Power Plug