Holtgreven GSE-665 - Manual (Page 41)

C H A P T E R 4 : C O U N T I N G M O D E
33
3. Press [ENTER]. The indicator tares to a zero net weight. The display
shows the current net weight and the prompt: Add 10.
4. Place the specified number of parts on the scale.
5. Press [ENTER]. The indicator then calculates the piece weight of the
sample parts and momentarily displays the maximum number of parts
which may be added for a piece weight enhancement to occur. The
minimum achieved accuracy is then displayed.
6. If a greater accuracy is desired, add additional parts but not more than
the maximum enhanceable quantity.
7. As soon as motion ceases, the indicator will recalculate the piece weight
and then briefly display the new maximum number of pieces which can
be added and still accurately enhance the piece weight.
8. Repeat as many times as necessary to achieve the desired accuracy.
K
NOWN
C
ONTAINER
W
EIGHT
Place the full container of parts on the weigh platform. At any point in the
counting process, the known weight of a container can be keyed in followed
by the [TARE] key in order to cancel the affect of the container. Make
certain that the weighing units of your entry are consistent with the current
unit selection (lb, kg, etc.)
A
UTOMATIC
S
CALE
S
ELECT
(W
ITH
M
ORE
T
HAN
O
NE
W
EIGHING
P
LATFORM
)
The 60 Series has the capability of automatically selecting a predetermined
scale before and after the sample routine. One or more multi-scale option
cards must be installed for this feature to work.
One scale will be a pre sample and the other will be an after sample. During
operation, press the [ENTER] key and the indicator will automatically select
the predetermined sample scale. The prompt add XX will be displayed.
Place the specified number of pieces on the sample scale and again press
[ENTER]. The average piece weight having been established, the indicator
automatically selects the appropriate “bulk” scale for higher capacity
counting.