Holtgreven GSE-665 - Manual (Page 55)

C H A P T E R 8 : L E G A L - F O R - T R A D E
47
NTEP C
USTOM
S
ETUP
The “Custom Setup” parameter, P60205 of the information parameters,
displays a list of parameters, which, if configured improperly, could
facilitate fraud in a legal-for-trade installation. A weights and measures
inspector might check this parameter and inquire about the configuration of
any parameters that appear in this list.
A CCESSING THE C USTOM S ETUP L IST
DO NOT ATTEMPT TO ACCESS THE CUSTOM SETUP LIST
DURING CRITICAL WEIGHT PROCESSING! It is important to note
that all functions of the operating mode will be suspended immediately upon
accessing the information parameters. This includes suspension of weight
conversions, deactivation of all setpoints and cancellation of custom
transmits.
The “Custom Setup” list may be accessed from the Weigh Mode. An access
code is not required to view this list.
To access the custom setup list:
1. From the Weigh Mode, key in 60205 [SELECT].
2. The Custom Setup list begins scrolling through each parameter to check.
If there are no parameters to check, Std. Setup is displayed.
3. The Custom Setup list may be repeated by pressing [ENTER] at
P60205.
4. Press [ZERO] to return to the Weigh Mode.
A setup parameter that appears in the “Custom Setup” does not imply that it
is improperly configured. Consider the application and refer to the
following descriptions to determine if the parameter is configured
appropriately.
P205 – Receive Mode
If the receive mode is enabled for any of the four communication ports, any
device connected to that port should not be used to transmit data to the
M660 which could facilitate fraud.