Acura 2000 RL - Owner's Manual - Manual (Page 225)

Cooling System
4. On the right side of the engine
block, remove the clip with a plier,
and then remove the drain cap.
5. Remove the reserve tank from its
holder by pulling it straight up.
Drain the coolant, then put the
tank back in its holder.
6. When the coolant stops draining,
tighten the drain plug at the
bottom of the radiator.
Put the drain cap back in place
tightly, then reinstall the clip on
the drain cap securely.
7. Mix the recommended antifreeze
with an equal amount of purified
or distilled water in a clean
container. The cooling system
capacity is:
1.61 US gal (6.1 l ,1.34 Imp gal)
Maintenance
CLIP
DRAIN CAP
RESERVE TANK HOLDER
RESERVE TANK CAP
Main Menu
Main Menu Table of Contents