Acura 2000 RL - Owner's Manual - Manual (Page 256)

Lights
Replacing Front Turn Signal/
Parking and Side Marker Light
Bulbs
1. If you are changing the bulb on
the driver's side, start the engine,
turn the steering wheel all the way
to the right, and turn off the
engine. If you are changing the
bulb on the passenger's side, turn
the steering wheel to the left.
2. Use a flat-tipped screwdriver to
remove the holding clip from the
inner fender.
3. Pull the inner fender cover back.
4. Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
5. To remove the front turn signal/
parking light bulb, push it in
slightly and turn it
counterclockwise. To remove the
side marker bulb, pull it straight
out of its socket.
6. Install the new bulb in the socket.
7. Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
8. Test the lights to make sure the
new bulb is working.
9. Put the inner fender cover in place.
Install the holding clip. Lock it in
place by pushing on the center.
Maintenance
HOLDING CLIP
Main Menu
Main Menu Table of Contents