Acura 2000 RL - Owner's Manual - Manual (Page 227)

Cooling System
12.Install the engine cover. First
tighten the two bolts on the front
of the engine cover, then tighten
the three nuts on the engine cover.
Tightening torque:
7 lbf.ft (10 N.m,1.0 kgf.m)
13.Install the radiator cap, and
tighten it to the first stop.
14.Start the engine and let it run until
the radiator cooling fan comes on
at least twice. Then stop the
engine.
15.Remove the radiator cap. Pour
coolant into the radiator up to the
base of the filler neck and into the
reserve tank up to the MAX mark.
16.Start the engine and hold it at
1,500 rpm until the cooling fan
comes on. Turn off the engine.
Check the coolant level in the
radiator and add coolant if needed.
17.Install the radiator cap, and
tighten it fully.
18. If necessary, fill the reserve tank
to the MAX mark. Install the
reserve tank cap.
Maintenance
RESERVE TANK
Main Menu
Main Menu Table of Contents