Acura 2000 RL - Owner's Manual - Manual (Page 226)

Cooling System
8. Remove the two bolts and the
three nuts with a 7/16 in (10 mm)
wrench, then remove the engine
cover.
9. Loosen the bleeder bolt on top of
the engine.
Pour coolant into the radiator up
to the base of the filler neck.
Tighten the bleeder bolt when
coolant comes out in a steady
stream with no bubbles.
10.Fill the reserve tank to the MAX
mark. Install the reserve tank cap.
11.Check the level in the radiator,
add coolant if needed.
CONTINUED
Maintenance
NUTS
BOLTS
BLEEDER BOLT
Fill up to here FILLER NECK
Main Menu
Main Menu Table of Contents