Lights – Acura 2000 RL - Owner's Manual User Manual
Page 259
Advertising
Lights
Replacing a Rear License Bulb
1. Remove the license light assembly
by carefully prying on the left
edge of the lens with a flat-tip
screwdriver and pulling the
assembly out.
2. Remove the lens from the bulb
holder by pulling the lens while
squeezing the tabs on both sides
of the holder.
3. Pull the bulb straight out of its
socket. Push the new bulb in until
it bottoms in the socket.
4. Turn on the parking lights and
check that the new bulb is
working.
5. Put the lens back on the bulb
holder and push it until it latches.
6. Slide the right side of the light
assembly into the hole. Push on
the left side to latch the assembly
into place.
Maintenance
LIGHT ASSEMBLY
BULB HOLDER
BULB
LENS
Main Menu
Main Menu
Table of Contents
Advertising