ALTANA Micro-Haze Plus - Manual (Page 21)

20
The measuring unit is switched on
using the mode button. After this,
one of the different measuring
modes appears in the display
(fig. 4):
If the unit is in the holder the
special functions shown in figure 5
are also available.
The various modes are shown one
after another by pressing the mode
button several times. The desired
measuring mode can be selected
in this manner.
In the selected mode, measure-
ments are started by pressing the
operate button. The corresponding
measured value will be displayed.
The red measurement indicators
on the side light up during the
measurement operation.
The selected mode can be
changed by pressing the mode
button.
An arrow in the display indicated
that the displayed function will be
performed if the displayed button is
pressed.
6 Program Description
Fig. 4: Changing measuring modes
SAMPLE MODE SAMPLE MODE SAMPLE MODE SAMPLE MODE SAMPLE MODE
haze log. c.
haze log. c. haze log. c. haze log. c. haze log. c.
STATISTIC n=005 STATISTIC n=005 STATISTIC n=005 STATISTIC n=005 STATISTIC n=005
haze log. c.
haze log. c. haze log. c. haze log. c. haze log. c.
HA m=35.3 s= 0.8 HA m=35.3 s= 0.8 HA m=35.3 s= 0.8 HA m=35.3 s= 0.8 HA m=35.3 s= 0.8
20°m=86.9
20°m=86.9 20°m=86.9 20°m=86.9 20°m=86.9 s= 0.6 s= 0.6 s= 0.6 s= 0.6 s= 0.6
CLEAR MEMORY CLEAR MEMORY CLEAR MEMORY CLEAR MEMORY CLEAR MEMORY
-----> >> > >operate operate operate operate operate
PRINT STATISTIC PRINT STATISTIC PRINT STATISTIC PRINT STATISTIC PRINT STATISTIC
-----> >> > >operate operate operate operate operate
mode
mode
mode
mode
mode