ALTANA Temp-Chart User Manual
Page 26
Advertising
25
2.6 Set Pass/Fail
The Pass/Fail conditions can be set in the Pass/
Fail Tab.
Therefore you can select temperature-values and
all conditions of the Cure index as criterions and
can cover them with values.
Exceeding or falling short of the corresponding
value, is shown in red color in the analysis table.
In the Tab Pass/Fail events, sensor, criterion and
reason are shown.
In the data base list, the measurement is marked
according to Pass/Fail result with a red or green
point.
Set Pass Fail
Advertising