ALTANA Temp-Chart - Manual (Page 6)

5
1 Menus
1.1 Menu Data
The Commands in the Data Tab of the Tools Menu
The Data Tab contains commands for editing data
files or measurements. temp-gard-measurements
are saved in database. They do not only contain
the data values of the connected sensors (the
temperature curves) but also parameters descri-
bing the measurement setup. Therefore, the terms
File and Measurement here mean the same thing.
Please also refer to the chapter How to Work with
QC Procedures as it contains useful advice for an
easy operation of the program.
1.1.1 Section Measurement
The section Measurement contains the following
commands:
Import
Allows to import a measurement
saved in a single file into the current
database. These files (*.txt) may be
generated by the export command
(see below) or by a previous ver -
sion of the temp-chart software
(*.btr).
Export Saves the currently active measure-
ment into a single file that may for
example be sent via e-mail and
then be imported again into a diffe-
rent database (save as *.txt). You
may also choose to export the raw
data into an Excel sheet (save as
*.xls).
Menu Data