ALTANA Temp-Chart - Manual (Page 30)

29
Prepare a Measurement
3 Handling and Preparation
3.1 Prepare a Measurement
Connect the temp-gard to the PC or insert the
USB-Stick. Then activate the Instrument tab, make
sure you have selected the appropriate connection
settings and press
Select an organizer in the upcoming dialog and
press OK.
The Organizer will now be transferred to the USB
stick or the connected device and can be used
for new measurements. Already existing QC-
procedures can be selected and linked likewise.
3.2 Read Measurement Data
Step 1:
Measurements can be imported from the
instrument either directly (connected via USB or
the serial Port) or via a transport medium (an USB-
stick in case of a temp-gard 6p or temp-gard-12p,
or a SRAM card in case of temp-gard 8p). The
procedure is almost the same in all cases.
For a temp-gard 12p for example:
• Switch the temp-gard logger on
• Connect the USB Stick to the temp-gard logger
• Data will be transferred to the stick automati-
cally. If there are Organizers on the stick, the
Selection Menu „Configuration Files“ appears