ALTANA Temp-Chart - Manual (Page 32)

31
Read Measurement Data
These windows contain only the control information
if the instrument was not prepared with an
organizer.
As soon as you press close, the selected
measurement is imported and opened inside the
software.
This data is already registered, if the instrument
was prepared with temp chart and the used
organizers still exists.
As soon as you press close, the selected
measurement is imported and opened inside the
software.
If the measurement was taken with a QC
procedure, an automatic analysis takes place.
Otherwise, the QC procedure can be selected with
the data transfer.
Step 3:
It may be necessary to adjust the oven start
position. In this case
• Go to the Data menu
• Execute function Set Oven Start
• A vertical line will appear which can be fixed on
the real start point