ALTANA Temp-Chart User Manual
Page 27
26
2.7 Work with QC Procedures
temp-chart-QC-Procedures are the best solution
for recurring tasks:
Most measurements are serial measurements
which have to be carried out more than once,
and it is often difficult to keep the measurement
setup, i.e. the sampling interval or the number
of sensors, identical or at least comparable. The
matter becomes even more difficult when new
parameters, such as the product type and oven
speed, the tolerance and critical values have to be
defined anew for each measurement. For these
tasks,
temp-chart-QC-Procedures are the ideal
solution because they represent „measurements“
which - as yet - have no data values but which
already contain some or even all the parameters.
Anyway, in the QC-procedure the complete
measurement setup is saved, and in addition you
can enter and save all the additional information in
the organizer, such as comments, critical values,
tolerance and reference curves, oven setups etc.,
that are already known before the measurement.
This ensures that measurements prepared with the
same procedure are really comparable.
Work with QC Procedures