Imstmienm, Step 2, Anti-tip bracket installation – Kenmore 911.93508 User Manual
Page 4: T«p 3, Checking the installation, Mpomamt safety
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4-
mPOmAMT SAFETY
iMSTmienm
Anti-lip Brackat (cotitd.)
Step 2
Anti-tip bracket installation
A. Wood Construction:
1. Floor Drill a'/4'pilot hole in
the center of each pre-marked
wood floor hole position (a nail
or awl may be used if a drill is
not available),
AND
2. Wall: Drill an angled !4' pilot
hole (as shown in Fig. 2) in the
center of each pre-marked
wall hole position (a nail or awl
may be used if a drill is not
available).
ATTACHMENTTOWALLANDPLOOR
Bracket,
Screw Must
Enter Wood
or Metal
WaH
Plate
ng.2
B. Mount the ANTI-TIP bracket
with the 4 screws provided as
illustrated in Fig. 2.
C. Concrete Construction:
1. Hardware required:
4 each
y/ X 1
'A'
iag bolt
4 each ’/i' O.D. sleeve
anchor
2. Drill the recommended size
hole for the anchors into the
concrete at the center of each
pre-marked concrete floor and
wall hole position. Install the
sleeve anchor into the drilled
holes and then install the lag
bolts through the bracket.
DO NOT OVERTIGHTEN THE
BOLTS.
$t«p 3
Checking the installation
A. Complete the installation of
the range per the installation
instructions provided with it.
B. Check if the ANTHIP bracket is
installed and engaged properly.
Remove the kick panel or storage
drawer and inspect the REAR
LEVELING LEG. Make sure it fits
securely into the slot. See Fig. 1.
4
20Pia36ENv01.pni6
2/24«0,
9:34 AM