Pioneer VSX-D710S - Manual (Page 29)

Sound Modes
Switching ANALOG/DIGITAL
Signal Input
When you select a function (for example CD) that is
only hooked up by a digital connection, then the
ANALOG/DIGITAL signal input switch will
automatically choose digital for VSX-D810S/D850S If
you have that function hooked up by both digital and
analog connections this switch lets you choose which to
listen to
€) @ ©
© © © ©
_ MIA,n COHtSOl
© © © ©
® ® Cp
CD
® CD CD
.
® CD ^ ®
®
® ®
ooScSC
o 'S o o
Playing Sources with Dolby
Digital or DTS Sound
[0 0 0
©I© Q 0
® <p CD
CD ®
CD
cD""
(D
CD CD (g)
, aivgFO o access oum
CD ® ® ®
SM CLAS»
anamorr
tnvMB*i
® ®
UXQgM R.DMR SW IWTMS o o o o
0^ e-^
4
1 Press SIGNAL SELECT to select the input
signal corresponding to the source
component
Each press switches between ANALOG and DIGITAL
signal selection (VSX-D710S)
On the VSX-D810S & VSX-D850S receivers there is
an AUTO setting In this setting the receiver will
automatically switch between the analog and digital
signals according to what is being input If both
signals are input the AUTO setting will choose the
digital one This setting is convenient as the receiver
will always choose the best or appropriate signal
2 While SIGNAL SELECT is set to DIGITAL,
□□ DIGITAL lights when a Dolby Digital
signal is input, DTS lights when a DTS signal
is input
MEMO:
• SIGNAL SELECT is fixed in the “ANALOG” position
for components not assigned to one of the digital
input jacks
• This receiver can only play back Dolby Digital, PCM
(32kHz, 44kHz, and 48kHz [VSX-D810S & VSX-
D850S can play 96kHz]), and DTS, digital signal
formats With digital signal formats other than these,
set SIGNAL SELECT to “ANALOG”
• Some DVD players don’t output DTS signals For
more details, refer to the instruction manual supplied
with your DVD player
1 Turn on the power of the playback
component
2 Turn on the power of the receiver
Be sure that the standby indicator turns off on the
front panel
3 Press MULTI CONTROL buttons or the
FUNCTION button to select the source you
want to playback
If the DIRECT FUNCTION is OFF you have to use
the
FUNCTION button to select the source (see
p39)
4 Press SIGNAL SELECT to select DIGITAL
(Refer to “Switching ANALOG/DIGITAL signal input”
on this page)
5 Press DD/DTS to switch the Dolby/DTS mode
on
6 Start playback of the component you
selected in step 1
7 Press MASTER VOLUME (+/-) to adjust the
volume level
MEMO:
• You can only hear the sound on DTS encoded discs if
the CD or LD player with DTS is digitally connected
to this receiver If you play a DTS encoded disc
through analog connections you will only hear digital
noise, not the soundtrack To prevent noise, you need
to make digital connections (Refer to page 6-7) and
set SIGNAL SELECT to “DIGITAL” 29
En