Pioneer VSX-D710S - Manual (Page 50)

Additional Information
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions If you think that there is something wrong with
this component, check the points below Sometimes the trouble may lie in another component Investigate the other
components and electrical appliances being used If the trouble cannot be rectified even after exercising the checks
listed below, ask your nearest PIONEER authorized service center or your dealer to carry out repair work
50
En
The power does not turn ON
• Connect the power plug to the wall outlet
• Disconnect the power plug from the outlet, and insert
again
• Make sure there are no loose strands of speaker wire
touching the rear panel This could cause the receiver
to shut off automatically
The unit does not respond when the buttons are
pressed
No sound is output when a function is selected
• Make sure the component is connected correctly
(refer to pages 6 to 15)
• Press MUTING on the remote control
• Adjust MASTER VOLUME
• Press the MONITOR button
• Press SPEAKERS to select the speakers you
connected
No image is output when a function is selected
• Make sure the component is connected correctly
(refer to pages 6 to 15)
• Press the correct function button
Considerable noise in radio broadcasts
• Tune in the correct frequency
• Connect the antenna (refer to page 11)
• Route □□ RE and digital cables away from the
antenna terminals and wires
• Fully extend the FM wire antenna, position for best
reception, and secure to a wall
• Connect an outdoor FM antenna (refer to page 11)
• Adjust the direction and position for best reception
• Connect an additional internal or external AM
antenna (refer to page 11)
• Turn off the equipment causing the noise or move it
away from the receiver
• Place the antenna farther away from the equipment
causing the noise
Broadcast stations cannot be selected automatically
• Connect an outdoor antenna (refer to page 11)
No sound from surround or center speakers
• Refer to “SPEAKERS setting mode” on page 17 to
check the speaker settings
• Refer to “Setting the volume level of each channel” on
page 21 to check the speaker levels
• Connect the speakers (refer to page 12,13)
• Make sure that both A and B sets of speakers are not
switched on at the same time (A+B setting)
Sound is produced from other components, but not
from LD or DVD player
• Set SIGNAL SELECT to “DIGITAL” or “ANALOG”
according to the type of connections made (refer to
page 29)
• Set the digital input settings correctly (refer to pages
20 - 21 )
• Make digital connections (refer to page 6-7) and set
SIGNAL SELECT to “DIGITAL” (refer to page 29)
• Refer to the instruction manual supplied with the
DVD player
No audio is output when software with DTS is
played back
• Make sure your DVD is digitally connected to this
receiver (refer to page 6-7) and set the SIGNAL
SELECT to “DIGITAL”
When a search is performed by a DTS compatible
CD player during playback, noise is output
• This is not a malfunction, but be sure to turn the
volume down to prevent the output of loud noise
from your speakers
Cannot be remote controlled
• Replace the batteries (refer to page 4)
• Operate vsdthin 23 feet ( 7 m ) , 30° of the remote
sensor on the front panel (refer to page 4)
• Remove the obstacle or operate from another
position
• Avoid exposing the remote sensor on the front panel
to direct light
The display is dark or off
• Press FL DIMMER on the remote control repeatedly
to return to the default
If the unit does not operate normally due to external
effects such as static electricity
Disconnect the power plug from the outlet and insert
again to return to normal operating conditions