Memo, Playing other sources, Midnight listening mode – Pioneer VSX-D710S User Manual
Page 31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Sound Modes
DVD 5.1 ch./7.1 ch (5.1 ch for VSX-
D710S) input playback
If you want you can connect a component with 7 1
channel (5 1 channel for VSX-D710S) analog output to
enjoy surround sound playback In this case the
surround sound will be externally decoded and then fed
into the receiver
DVD/LD
MULTICONTROL-
RCV-
t
:
I I
51/71
® © (
€> ©_© ©
€) © © ©
® ® cp>
CD
CD cD””D
CD ^
CutSS DTVtfMW P1VWHU I
1 Press RCV
This sets the remote to select the sound mode
(You can skip this step when using the controls on
the receiver )
2 Press MIDNIGHT
Each press switches MIDNIGHT listening mode on or
off
MEMO;
• The effect automatically adjusts according to the
volume level
Playing other Sources
To switch on DVD 7 1 ch (5 1 ch for VSX-
D710S) mode press the DVD/LD MULTI
CONTROL button on the remote, then RCV,
then 5.1/7.1 button
VSX-D710S only: On the main unit press the
DVD 5 1CH button to switch on 5 1 ch mode
Press the 5 1/7.1 button on the remote to go
back to the DVD/LD mode If you’re using
the main unit, choose any other function
with the MULTI JOG
MEMO:
• When 5 1 ch/7 1 ch input is selected, Dolby mode,
DSP mode, SIGNAL SELECT, ATT, DIRECT, TONE,
MIDNIGHT mode, LOUDNESS and speakers B
cannot be operated
• When 5 1 ch/7 1 ch input is selected, only the
volume level and channel levels can be set
MIDNIGHT Listening Mode
When listening at low volume, surround effects tend to
become less than satisfactory Turn the MIDNIGHT
listening mode on to enjoy the effects of quality
surround sound even at low volumes This mode allows
you to hear effective surround sound of movies at low
volume levels
T---------
5n_\_
7
2
@ © Q
© © © ©
_ Muin coKimn
© © © 0
D <D Cp
CD CD™D
<S) CD ,
BS
w
class
OTVOWPff CPTVUENU I
® ® ® ® I
(Q 0 0 ©
0^0 0 0
(D CD CD
j ® CD
CD CD”
c
D
® CD ®
® ® <s®
WW>
tma/oir Btvjjpu I
O
CD O (3-
2
3
4
Turn on the power of the playback
component
Turn on the power of the receiver
Be sure that the standby indicator turns off on the
front panel
Press MULTI CONTROL buttons or the
FUNCTION button to select the source you
want to playback
If the DIRECT FUNCTION is OFF you have to use
the FUNCTION button to select the source (see
p39)
If necessary, press SIGNAL SELECT to select
the input signal corresponding to the source
component (see p 29)
Start playback of the component you
selected in step 1
31
En