Pioneer VSX-D710S - Manual (Page 3)

IMPORTAI\rT SAFETY INSTRUCTIONS
READ INSTRUCTIONS — All the safety
and operating instructions should be
read before the product is operated
RETAIN INSTRUCTIONS—The safety and
operating instructions should be retained
for future reference
HEED WARNINGS — All warnings on the
product and in the operating instructions
should be adhered to
FOLLOW INSTRUCTIONS—All operating
and use instructions should be followed
CLEANING — Unplug this product from the
wall outlet before cleaning The product
should be cleaned only with a polishing
cloth or a soft dry cloth Never clean
with furniture wax benzine, insecticides
or other volatile liquids since they may
corrode the cabinet
ATTACHMENTS—Do not use attachments
not recommended by the product
manufacturer as they may cause
hazards
WATER AND MOISTURE — Do not use
this product near water — for example
neara bathtub, wash bowl kitchen sink
or laundry tub; in a wet basement; or
near a swimming pool; and the like
ACCESSORIES—Do not place this product
on an unstable cart stand, tripod
bracket, or table The product may fall
causing serious injury toa child or adult
andseriousdamagetotheproduct Use
only with a cart stand tripod bracket
or
table recommended by the
manufacturer, or sold with the product
Any mounting of the product should
follow the manufacturer s instructions
and should use a mounting accessory
recommended by the manufacturer
CART — A product and cart combination
shouldbemovedwithcare Quickstops
excessive force and uneven surfaces
may cause the product and cart
combination to overturn
VENTILATION — Slots and openings in the
cabinet are provided for ventilation and
to ensure reliable operation of the
product and to protect it from
overheating, and these openings must
notbe blocked or covered The openings
should never be blocked by placing the
product on a bed, sofa, rug or other
similar surface This product should not
be placed in a built-in installation such
as a bookcase or rack unless proper
ventilation
is provided or the
manufacturer s instructions have been
adhered to
POWER SOURCES — This product should
be operated only from the type of power
source indicated on the marking label If
you are not sure of the type of power
supply to your home consult your
product dealer or local power company
LOCATION - The appliance should be
installed in a stable location
NONUSE PERIODS - The power cord of
the appliance should be unplugged from
the outlet when left unused for a long
period of time
GROUNDING OR POLARIZATION
•
If this product is equipped with a
polarized alternating current line plug (a
plug having one blade wider than the
other), it will fit into the outlet only one
way This is a safety feature If you are
unable to insert the plug fully into the
outlet try reversing the plug If the plug
should still fail to fit contact your
electrician to replace your obsolete
outlet Do not defeat the safety purpose
of the polarized plug
• If this product is equipped with a three-
wire grounding type plug a plug having
a third (grounding) pin it will only fit into
a grounding type power outlet This is a
safety feature If you are unable to insert
the plug into the outlet contact your
electrician to replace your obsolete
outlet Do notdefeatthe safety purpose
of the grounding type plug
POWER-CORD PROTECTION — Power-
supply cords should be routed so that
they are not likely to be walked on or
pinched by items placed upon or against
them paying particularattention to cords
at plugs convenience receptacles and
the point where they exit from the
product
OUTDOOR ANTENNA GROUNDING — If
an outside antenna or cable system is
connected to the product be sure the
antenna or cable system is grounded so
as to provide some protection against
voltage surges and built-up static
charges Article 810 of the National
Electrical Code, ANSI/NFPA70 provides
information with regard to proper
grounding of the mast and supporting
structure grounding of the lead-in wire
to an antenna discharge unit size of
grounding conductors location of
antenna-discharge unit connection to
grounding electrodes and requirements
for the grounding electrode See Figure
A
LIGHTNING—For added protection for this
product duringa lightning storm or when
it is left unattended and unused for long
periods of time unplug it from the wall
outlet and disconnect the antenna or
cable system This will prevent damage
to the product due to lightning and
power-line surges
POWER LINES — An outside antenna
system should not be located in the
vicinity of overhead power lines or other
electric light or power circuits or where
itcanfall into such power lines or circuits
When installing an outside antenna
system extreme care should be taken
to keep from touching such power lines
or circuits as contact with them might
be fatal
OVERLOADING — Do not overload wall
outlets extension cords or integral
convenience receptacles as this can
result in a risk of fire or electric shock
OBJECT AND LIQUID ENTRY — Never
push objects of any kind into this product
through openings as they may touch
dangerous voltage points or short-out
parts that could result in a fire or electric
shock Never spill liquid of any kind on
the product
SERVICING — Do not attempt to service
this product yourself as opening or
removing covers may expose you to
dangerous voltage or other hazards
Refer all servicing to qualified service
personnel
DAMAGE REQUIRING SERVICE—Unplug
this product from the wall outlet and
refer servicing to qualified service
personnel
under the following
conditions;
• When the power-supply cord or plug is
damaged
• If liquid has been spilled, or objects
have fallen into the product
• If the product has been exposed to rain
or water
• If the product does not operate normally
by following the operating instructions
Adjust only those controls that are
covered by the operating instructions
as an improper adjustment of other
controls may result in damage and will
often require extensive work by a
qualified technician to restore the
product to its normal operation
• If the product has been dropped or
damaged in any way
• When the product exhibits a distinct
change in performance—this indicates
a need for service
REPLACEMENT PARTS — When
replacement parts are required be sure
the service technician has used
replacement parts specified by the
manufacturer or have the same
characteristics as the original part
Unauthorized substitutions may result
in fire, electric shock or other hazards
SAFETY CHECK— Upon completion of any
service or repairs to this product ask
the service technician to perform safety
checks to determine that the product is
in proper operating condition
WALL OR CEILING MOUNTING — The
product should not be mounted to a
wall or ceiling
HEAT — The product should be situated
away from heat sources such as
radiators heat registers stoves or other
products (including amplifiers) that
produce heat
Fig A
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
■GROUND CLAMPS
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PARTH)
NEC — NATIONAL ELECTRICAL CODE
3
En