Toshiba TEC MA-85-100 - Manual (Page 111)

EO1-11072
)
23. Status Clear and Memory Clear Operations
The operations described in this chapter are provided for initial start-up of the
machine or emergency but not to be operated as part of daily routines. Do not
perform any of these operations unless it is really necessary.
Status Clear
The operation defined as “Status Clear* will only clear an error or key-locked condition that
disables normal operations (though it seldom happens). Thus neither the sales data nor the
programmed data will be cleared by a Status Clear (except that when a Status Clear is operated
to clear a key-locked condition during a sale, the sale item data already entered for the current
sale will be cleared).
The Status Clear also has the function to obtain the condition “after all sales data resets* (as if all
sales data had been reset) but will not actually affect any sales data. Such a condition is required
in some programming operations and is usually obtained by taking the required reset reports.
However, when you do not want the sales data to be reset because it is still In the business
hours, etc., this function of the Status Clear will be effective. But be careful in using the function;
depending on the programming item, sales data resets may really be necessary instead of a
Status Clear, to keep consistency between the programmed data and the sales data.
Operating Procedure
Condition: Any time, outside or during any operation sequence
Operation:
Remove the plug of the register’s power cord from the wall outlet (to turn OFF the power).
I
Use the S Key to turn the
Control Lock to “BLIND*.
i
Plug in the cord (to turn ON the power).
A Status Clear receipt is issued.
Status Clear Symbol Line
Date, ConsecuSve No., and Time
are not reset
Thank you
Call again
11.- l г - 9 3
^ 0 0 * a o o
0 2 7,1
1 3 - 0 4
Zero-amount Display & Print Format
(may vary depending on the designadon in the last
“Sales Memory Clear" or “All Memory C/ear" (refer
to the following pages.) tnWal Formai; 0.00
- 111 -