System option setting, Programming procedure, System option setting ) – Toshiba TEC MA-85-100 User Manual
Page 85
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
EOl-11072
17. System Option Setting
)
This chapter is provided for your selections of the register’s basic functions
according to the market and your requirements, some of which are already
indicated for reference in other chapters as to print/non-print items, key
functions, etc.
Programming Procedure
The System Options are divided into 11 addresses (Addresses 1 to 16; Addresses 4, 5, 9, 10
and 12 are vacant) and each address is further divided into a maximum of 8 bits (Bits 1 to 8).
Each Address table is placed on the following pages.
Condition: After Daily Financial Reset
(refer to “NOTE on Condition“ on page 20)
Programming Procedure:
Use the MA Key to turn the Control Lock to “SET.”
“SET” status, enter “0” for the Address.
Examples) To SET Bit 2 only ............................................... Enter 2.
To SET Bits 2 and 3 ........................................ Enter 23.
To SET all the Bits........................................... Enter 12345678.
To RESET all the Bits ...................................... Enter 0.
To change any Bit in an Address, enter the Address No. and enter all the SET Bit
Nos again. If a Bit No. is not included in the SET Bit Nos, the Bit will be RESET.
- 8 5 -