Programming department lcs (listing capacities), L^dd – Toshiba TEC MA-85-100 User Manual
Page 37
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
EOl -11072
Department Status Program Receipt Format:
Key Operation
Control Lock: SET
\3\
iKev Type Status'*
0: Itemized
1: Single-itemj
¡Tax StaFus fPST)
Non-taxable
Tax 1 Taxable
Tax 2 Taxable
Both Tax 1 &
Tax 2 Taxable
I
Blank:
GST Non-taxable
L .
)
Programming Department LCs (Listing Capacities):
The LC setting is used to check an amount limit error. By setting the LC, an amount entry
(due perhaps to a mistake by the operator) will be preyented at the earliest stage (i.e. an
error will result on entering an excessive amount through the department key).
Condition:
After Daily Financial Reset
(refer to “NOTE on Condition” on page 20)
Programming Procedure:
Use the MA Key to turn the
Control Lock to “SET”.
X
REG
OFF
As
for items marked with "NOTE", refer to the
corresponding
NOTE
No. on
(be next
page for further description.
8
@/FOR
SET
Declaration of Program
No. 8 for Department LC
programming
Repeat for setting LCs of other
cfeparfmenfs.
□□
Dept
2-digtt LC code
for each department
NOTES i, 2
1-L^DD
AT/TL
Common 2-digit LC code
for all departments NOTES
i, 2
J
ex.)
SE-
L
I
----------- 4
digits-----------
f
Value
of the top digit---------- 1
indicates $ 39.99
Allows to enter equal to
or smaller than $39.99 in
sale entries.
-35 -