Toshiba TEC MA-85-100 - Manual (Page 23)

EOl-11072
)
1) Tax 1: Full Breaks (Non-cvciic Breaks + Cyclic Breaks)
[max, amount non-taxable[ —► I
txi / m
[max, amount for 1C tax levied|
[max, amount for gg tax levied]
TXl/M
TXI/M
Repeat up to the “A** Break.
[max, amount for Nc tax levied] -
► I TXI/M I ........... Break
(to indicate the **A*' Break entry)
[max, amount for N -M c tax levied] -
[max, amount for N + 2c tax levied] -
Non-cyclic
Tax Breaks
TXI/M
TXI/M
Repeat up to the "S” Break.
|“B” Break] TXI/M
I
rB" Break - “A” Break
= a multiple of $1.00)
Cyclic
Tax Breaks
(to complete this tax table setting)
NOTB: Bach amount (break) entry may be a maximum of 4-digit value (99990).
)
2) Tax 1: “A” Break and % Rate Combination (Non-cvcIic Breaks + % Rate)
First, set all the non-cyclic breaks up to the “A” Break entry and the [ST] key
depression shown in the above case of “1) Tax 1 Full Breaks”.
[Tax Rate applied when exceeding the “A” Break amount]
(Max. 6 digits up to 99.9999%. Use the [. ] key for a decimal value. Examples: To
set 5%, enter 5. To set 5.26%, enter 5->[ . ]-»2->6. The fraction of the amount
resulting from this % rate calculation will be rounded off.)
i
(to complete this tax table setting)
3) Tax 1: % Rate Only
TX1/M I (to indicate that no breaks are entered)
[Tax Rate applied to any amount] —►
(The description for the Tax Rate in the above case 2) is also applied to this case.)
- 2 1 -