Futaba 3PM-X 2.4GHz - Manual (Page 13)

13
Before Using
- Racing timer (TIMER) : Up timer or Down timer can be selected.
A lap time can record 100 lap times and the total time. The timer can also be started
automatically by trigger operation. The race time can be set.
- Digital trim: Steering trim, Throttle trim, Steering D/R, Throttle ATL
The current position is displayed on the LCD screen for about three seconds when
each digital trim is operated.
- Function select lever function (FNC-DT1/DT2/DT3/DT4)
This function assigns a function to levers (digital trims, grip levers). Trim positioning
at each model call is unnecessary because all the levers are digital.
- Digital trim step function (STP-DT1/DT2/DT3/DT4)
The digital trim (DT1/DT2/DT3/DT4) step amount can be adjusted by means of this
function.
- Function select switch function (FNC-SW1/SW2)
This function assigns a function to the two installed switches.
- Condition 2 Selection
In specific functions, two rates can be set up, and switched with SW1 switch simulta-
neously during a run.
- NEW design considers operability and weight balance
- Adjuster function (ADJ)
Steering wheel and throttle trigger neutral position and operating angle correction
can be applied.
- Tension adjustment function
The wheel tension can be adjusted from the outside.
- Trigger stopper function (Mechanical ATL)
- High luminosity blue LED pilot lamp
You can select your desired brightness of the pilot lamp. (Four steps)