Futaba 3PM-X 2.4GHz - Manual (Page 33)

33
Functions
Setup item
SPD-TN: TURN direction
SPD-RN: RETURN direction
Adjustment range
0~100% (each direction)
Adjustment buttons
- Use the (+) and (-) buttons to make
adjustments.
- Return to the initial value by pressing
the (+) and (-) buttons simultaneously
(approx. 1 sec).
Steering Speed (SPD) adjustment
(Preparation)
- Select setup item "SPD-TN" and make the following
adjustments:
1
"TN" direction adjustment
Use the (+) and (-) buttons to adjust the delay
amount.
2
"RN" direction adjustment
Select setup item "SPD-RN" and use the (+)
and (-) buttons to adjust the delay amount.
3
When ending adjustment, return to the initial
screen by pressing the (SEL) button.
100% 1%
Setting range: 1~100%
At 100%, there is no delay.
At 1%, the delay is approximately 1.5
seconds.
Servo operation is delayed.
1.5 0.1
1.5 0.1
"TURN"
"RETN"
Steering Speed/SPD
Quick steering operation will cause momentary understeering, loss of speed, or spin-
ning. This function is effective in such cases.
Understeering
Spin
Smooth cornering
Steering speed not set Steering speed set
Operation
- This function limits the maximum speed of
the steering servo. (Delay function)
- The steering speed when the steering wheel
is operated (TN direction) and returned (RN
direction) can be independently set.
TN direction
Turning speed adjustment range
Stick operation
RN direction
Return speed adjust-
ment range
- If the steering wheel is turned
slower than the set speed, the steer-
ing servo is not affected.
Time
(Initial screen)
Press "SEL" key to select the
desired function screen.
Calling the setup screen
(Setup screen)
Press "CH" key to select the next set-
up screen.