Futaba 3PM-X 2.4GHz - Manual (Page 60)

60
Functions
Adjuster / ADJ
Steering wheel and throttle trigger neutral position and operating angle correction
can be applied. However, when correction is applied, the set values of all the setting
functions must be reconfirmed.
Steering wheel and throttle trigger adjustment
(Preparation)
-Select the desired channel setup item and make the following adjustments.
Steering wheel:
1
(Neutral position correction)
Hold the steering wheel to the neutral position and
when the (+) and (-) buttons are pressed simulta-
neously, the neutral position is corrected.
2
(Operating angle correction)
Turn the steering wheel fully to the left and right,
and press the (+) and (-) buttons simultaneously.
Throttle trigger:
1
(Neutral position correction)
Hold the throttle trigger to the neutral position and
when the (+) and (-) buttons are pressed simulta-
neously, the neutral position is corrected.
2
(Operating angle correction)
Pull the throttle trigger fully to the high side and
pull it to the brake(reverse) side, and press the (+)
and (-) buttons simultaneously.
- Check the servo operation after adjusting.
When ending adjustment, turn off the power switch before use.
Calling the setup screen
1. Turn on the power switch
while pressing "SEL" key. 2. Next, use "SEL" key to select
the desired function screen.