Futaba 3PM-X 2.4GHz - Manual (Page 37)

37
Functions
0% 100%
A.B.S function adjustment
(Preparation)
- Select setup item "ABS-MD" and make the following adjustments:
1
(Function ON/OFF)
Set the function to the active state by pressing the (+) or (-) button.
OFF : Function OFF
ON : Function ON
2
(Brake return amount adjustment)
Select setup item "ABS-PT" and use the (+) and (-) buttons to adjust the
return amount.
"0" : No return
"50" : Return to the 50% position of the brake operation amount
"100" : Return to the neutral position.
3
(Cycle speed adjustment)
Select setup item "ABS-CY" and use the (+) and (-) buttons to adjust the
speed.
- The lower the set value, the faster the cycle speed.
4
(Delay amount setup)
Select setup item "ABS-DL" and use the (+) and (-) buttons to adjust the
delay amount.
"0" : A.B.S. function performed without any delay
"50" : A.B.S function performed after an approximate 0.7 sec delay.
"100" : A.B.S. function performed after an approximate 1.4 secs delay.
5
When ending adjustment, return to the initial screen by pressing the (SEL)
button.