Futaba 3PM-X 2.4GHz - Manual (Page 43)

43
Functions
4WS mixing adjustment
(Preparation)
- Select setup item "4WS-MD" and make the following adjustments.
1
(Function ON/OFF)
Set the function to the "2cy" or "4cy" state by pressing the (+) or (-) button.
"OFF": Function OFF, "2cy": 2cy mode, "4cy": 4cy mode
2
(Master MIX mode ON/OFF)
Select setup item "MST-MX" and set the function to the "ON" or "OFF" by
pressing the (+) or (-) button.
3
(Mixing amount adjustment)
Select setup item "4WS-RT" and use the (+) and (-) buttons to adjust the
mixing amount.
4
When ending adjustment, return to the initial screen by pressing the (SEL)
button.
Mixing amount
0~100
Initial value: 100
Adjustment buttons
- Use the (+) and (-) buttons to make
adjustments.
- Press the (+) and (-) buttons simul-
taneously (approx. 1 sec) to return to
the initial screen.
(Initial screen)
Press "SEL" key to select the
desired function screen.
Calling the setup screen
(Setup screen)
Press "CH" key to select the next set-up
screen. (Only when MD is 2cy or 4cy)
Setting items
4WS-MD: Function OFF/2cy mode/
4cy mode selection
MST-MX: Master MIX mode ON/
OFF
4WS-RT: Mixing rate
Advice
Linkage at 4WS function selection
1. After connecting the linkage, use the servo reverse function to change the
direction of operation of the front and rear wheels so that it is the same mode as
the operation mode (F1/F2/F3/F4) being selected.
2. Thereafter, use the end point adjuster to adjust the left and right steering
angles.
3. Finally, use 4WS-RT to adjust the mixing amount. In addition, when you
want to change the mixing amount by digital trim, select 4W at the function
select lever setup screen.