Futaba 12Z - Manual (Page 124)

124 <Data>
Line (LINE) and curve (SPLINE) adjustment
(Line)
(Spline)
Lines or splines of up to 17 points can be
used. (Initial value: 9 points) The set points can
be freely increased, decreased, and offset.
[Rate adjustment of each point]
1. Use the cursor lever to move the cursor
(reverse-display) to the [POINT] item and
turn the data input dial to the left or right
and select the point whose rate you want
to set. (The position of the square box on
the curve is the selected point.)
2. Move the cursor to the [RATE] item and set
the rate by turning the data input dial to
the left or right.
[Point addition]
1. Use the cursor lever to move the cursor
to the [POSITION] item and turn the data
input dial to the left or right and move the
square box to the position you want to
add.
 :KHQ WKH HQWHU EXWWRQ LV SXVKHG IRU 
second, the selected point is added.
[Point deletion]
1. Use the cursor lever to move the cursor to
the [POINT] item and turn the data input
dial to the left or right and select the point
you want to delete.
 :KHQ WKH HQWHU EXWWRQ LV SXVKHG IRU 
second, the selected point is deleted.
[Offsetting the curve horizontally in the
vertical direction]
1. Use the cursor lever to move the cursor
(reverse-video) to the [OFFSET] setting
item.
2. Move the curve in the vertical direction by
turning the data input dial to the left or right.
Initial value: +0.0%
(When the enter button is pushed for 1 second, the curve is
reset to the initial value.)