Futaba 12Z - Manual (Page 68)

68 <Functions of Linkage Menu>
COND.HOLD
&RQGLWLRQKROGIXQFWLRQ
7KLVIXQFWLRQPD\EHXVHGWR¿[WKHPD[LPXP
speed of the engine so that you may adjust flight
conditions when the engine is running. An alarm
indicates that the function is operating. It will
prevent the engine from racing dangerously when
adjusting the Idle-Up settings.
While this function is active, the throttle servo
position is fixed at the point where you operate
when the function is activated. You must deactivate
this function when you are through making
adjustments.
The system will not allow you to activate/
deactivate this function in either of the following
states:
‡ :KHQ DQ\ RI WKH IOLJKW FRQGLWLRQ VZLWFKHV
DUHRQ
‡ :KHQ WKH WKURWWOH VWLFN LV KLJKHU WKDQ WKH
SRLQW
To activate/deactivate Condition hold:
(Home screen)
0RYHWKHFXUVRUWR>&1'+2/'@
6HWWKHWKURWWOHVWLFNORZHUWKDQWKHSRLQW
 3XVK WKH HQWHU EXWWRQ WR DFWLYDWH WKH
FRQGLWLRQKROGIXQFWLRQ
*When this function is active, "IS ACTIVE" appears at the
bottom of the [CND HOLD] display at the left bottom of the
screen.
(LINKAGE menu/MODEL menu)
0RYHWKHFXUVRUWR>&21'+2/'@
6HWWKHWKURWWOHVWLFNORZHUWKDQWKHSRLQW
 3XVK WKH HQWHU EXWWRQ WR DFWLYDWH WKH
FRQGLWLRQKROGIXQFWLRQ
*Operation is displayed at the bottom of the menu.
Function ON: "CND HOLD: ACT(ON)" is displayed.
Function OFF: "CND HOLD: INH(OFF)" is displayed.