Futaba 12Z - Manual (Page 14)

14 <Before Use>
Volume
Volume LD, CD, and RD:
The volume LD and RD are analog type. You can
recall the dial position data at the last operation in
the Dial Monitor screen (Linkage Menu function.)
The volume CD is digital type (rotary encoder).
This volume works as both a volume and a push-
switch.
*T12Z beeps when the volume knob reaches center.
*You can check the volume position of the LD/RD functions
in the Dial Monitor screen in the Linkage menu.
*You can use each setting screen of the mixing functions to
VHOHFWYROXPHVDQGGH¿QHWKHGLUHFWLRQRILWVPRYHPHQW
Slide Lever
LS (Left), RS (right):
The side lever LS and RS are analog type.
You can recall the lever position data at the last
operation in the Dial Monitor screen (Linkage
Menu function.)
*T12Z beeps when the lever comes to the center.
*You can check the lever position on the dial-monitor screen
in the linkage menu.
*You can select a slide lever and set the movement direction
on the setting screen of mixing functions.
Digital trim
This transmitter is equipped with digital trims.
Each time you press a trim button, the trim position
moves one step. If you continue pressing it, the trim
position starts to move faster. In addition, when
the trim position returns to the center, the tone will
change. You can always monitor trim positions by
graphics on the screen.
To change the trim rate, you must activate this
through the function menu, within the linkage
menu. Use the cursor lever to select the trim box
and then push the enter button and you will access
another screen which enables you to change the
trim percentages.
Note: The trim positions you have set will be stored in the
non-volatile memory and will remain there.