Futaba 12Z - Manual (Page 57)

57 <Functions of Linkage Menu>
PUSH
[Cursor Lever]
Ɣ0RYHPHQWRQWKH
VFUHHQ GLUHFWLRQV
Ɣ3XVKWKHOHYHUWRFDOO
QH[WSDJH
[Data Input Dial]
[Enter Button]
[Return Key]
Ɣ7RKRPH
VFUHHQ
Ɣ7RSUHFHGLQJ
VFUHHQ
SUB-TRIM
6HWWLQJRIQHXWUDOSRVLWLRQRIHDFKVHUYR
(The display screen is an example. The screen depends on the model type.)
The Sub-Trim function is used to set the servo
neutral position, and may be used to make fine
adjustments to the control surface after linkages
and pushrods are hooked up. When you begin to set
up a model, be sure that the digital trims are set to
their center position.
Sub trim adjustment
8VHWKHFXUVRUOHYHUWRPRYHWKHFXUVRUWRWKH
FKDQQHO\RXZDQWWRDGMXVW
$GMXVWE\WXUQLQJWKHGDWDLQSXWGLDO
 ,QLWLDOYDOXH 
 $GMXVWPHQWUDQJH a VWHSV
(When the enter button is pushed for 1 second, sub trim is
reset to the initial value.)
*Before sub trim adjustment, adjustment of the linkage so that
control surfaces need not use sub trim as much as possible is
very important.
5HSHDWWKLVSURFHGXUHIRUHDFKFKDQQHO
ŏ6HOHFW>68%75,0@DWWKHOLQNDJHPHQXDQGFDOOWKH
VHWXS VFUHHQ VKRZQ EHORZ E\ SXVKLQJ WKH HQWHU
EXWWRQ
ﴶﴸﴸﳜ
ﶮﶪ﷐ﶀﶬﶰﷂﶺ
ﻤｆ
Ｊ＜Ｊ
ﴂﴜﴀﴜﳾﳰ ﳌ ﴂﴈﳾﴤﴂﳴﳒﴐﴜﳴﳚﴶ ﳌ ﴀﴜﴠﳘ
ﴠﴖﴶ
ﻤｆ
０＊Ｌ
ﴠﴖﴴ
，Ｄ０
ﴠﴖﴲ
ＲＢ＜
ﴠﴖﴰ
ＦＪＲ０
ﴠﴖﴮ
ＲＰ＞
ﴠﴖﴬ
ﻤｆ ﻤｆ ﻤｆ ﻤｆ
ﶺﶶ﷌﷊ﶼ﷤ ﷎ﶶﶸ﷌ﷂﶬ﷤
ﴶﴸﳰﴶﴸﳰﴸﴸ