Interlogix TruVision 360° Configuration Manual - Manual (Page 12)

10 TruVision 360° Camera Configuration Manual
2. From the Time Zone drop-down menu, select the time zone that is the closest to the
camera’s location.
3. Under Time Sync , check one of the options for setting the time and date:
Synchronize with an NTP server: Check the NTP enable box and enter the server
NTP address. The time interval can be set from 1 to 10080 minutes.
- Or -
Set manually: Enable the Manual Time Sync function and then click to set the
system time from the pop-up calendar.
Note: You can also check the Sync with computer time checkbox to synchronize
the time of the camera with the time of your computer.
4. Check Enable DST to enable the DST function, and set the start and end dates of
the DST period.
5. Click Save to save changes.
Defining RS-485 settings
The RS-485 serial port is used to control extra devices that support the 485 protocol
(Pelco D or Pelco P), such as PTZ devices, lighting devices or other devices. You can
also connect it to an analog PTZ camera, using a 360° camera to control PTZ
movement.
You need to configure these parameters before connecting the camera to any devices.