Interlogix TruVision 360° Configuration Manual - Manual (Page 26)

24 TruVision 360° Camera Configuration Manual
4. Click and drag the mouse in the live video window to draw the mask area.
Note: You are allowed to draw up to 4 areas on the same image.
5. Click Stop Drawing to finish drawing, or click Clear All to clear all of the areas you
set without saving them.
6. Click Save to save changes.
Motion detection alarms
You can define motion detection alarms. A motion detection alarm refers to an alarm
triggered when the camera detects motion. However, the motion alarm is only triggered
if it occurs during a programmed time schedule.
Select the level of sensitivity to motion as well as the target size so that only objects
that could be of interest can trigger a motion recording. For example, the motion
recording is triggered by the movement of a person but not that of a cat.
You can define the area on screen where the motion is detected, the level of sensitivity
to motion, the schedule when the camera is sensitive to detecting motion as well as
which methods are used to alert you to a motion detection alarm.
You can also enable dynamic analysis for motion. When there is motion, the area will
be highlighted as green.
Figure 11: Motion detection menu
Defining a motion detection alarm requires the following tasks:
1. Area Settings: Define the on-screen area that can trigger a motion detection alarm
and the detection sensitivity level.
2. Arming Schedule: Define the schedule during which the system detects motion.